期刊导航

论文摘要

考虑实际气体效应双列螺旋槽干气密封反转性能分析

Analysis on the Performance of the Reverse Rotation of Double-spiral Groove Dry Gas Seal Considered Effect of Real Gas Behavior

作者:孙雪剑(昆明理工大学 机电工程学院, 云南 昆明 650500);宋鹏云(昆明理工大学 机电工程学院, 云南 昆明 650500;昆明理工大学 化学工程学院, 云南 昆明 650500);毛文元(昆明理工大学 化学工程学院, 云南 昆明 650500);邓强国(昆明理工大学 机电工程学院, 云南 昆明 650500);许恒杰(昆明理工大学 化学工程学院, 云南 昆明 650500)

Author:SUN Xuejian(Faculty of Mechanical and Electrical Eng., Kunming Univ. of Sci. and Technol., Kunming 650500, China);SONG Pengyun(Faculty of Mechanical and Electrical Eng., Kunming Univ. of Sci. and Technol., Kunming 650500, China;Faculty of Chemical Eng., Kunming Univ. of Sci. and Technol., Kunming 650500, China);MAO Wenyuan(Faculty of Chemical Eng., Kunming Univ. of Sci. and Technol., Kunming 650500, China);DENG Qiangguo(Faculty of Mechanical and Electrical Eng., Kunming Univ. of Sci. and Technol., Kunming 650500, China);XU Hengjie(Faculty of Chemical Eng., Kunming Univ. of Sci. and Technol., Kunming 650500, China)

收稿日期:2018-07-13          年卷(期)页码:2019,51(4):176-184

期刊名称:工程科学与技术

Journal Name:Advanced Engineering Sciences

关键字:干气密封;螺旋槽;状态方程;反转能力;数值法

Key words:dry gas seal;spiral groove;real gas effect;reverse rotation capability;analytical method

基金项目:国家自然科学基金项目(51465026)

中文摘要

离心式压缩机在实际生产运行中,因故障停机时会发生反转,要求配置的干气密封具有一定的抗反转能力。针对双列螺旋槽干气密封,选用CO2作为密封介质。用R-K方程表达实际气体效应,修正气体润滑Reynolds方程,分析在反转情况下,不同转速、膜厚、压差以及反向螺旋槽径向尺寸与正向螺旋槽径向尺寸之比(ε)对密封性能的影响。分别获得了正转、反转和静止3种状态下的端面开启力、泄漏率、气膜刚度和开漏比等密封性能参数。以气膜零刚度反转速度为抗反转能力性能指标,结果表明:CO2实际气体端面开启力和泄漏率大于理想CO2气体,而开漏比小于理想气体,分析CO2气体润滑的双列螺旋槽干气密封性能需要考虑实际气体效应。双列螺旋槽干气密封具有一定的抗反转能力,当反转速度小于气膜零刚度反转速度时,干气密封可以正常操作。以气膜零刚度时的反转速度为最大值,本计算案例最大反转速度为2 524 r/min。

英文摘要

Centrifugal compressors will be reverse during shutdown due to failure in actual application, so the dry gas seal applied in compressors should possess some ability to the reverse rotation. The double-row spiral groove dry gas seal was taken as an example and the CO2gas was used as the sealing medium. The opening force, leakage rate, gas film stiffness and ratio of opening force to leakage rate etc were calculated at the rotation of forward, stop and reverse. The speed of reverse rotation at which the gas film stiffness equals to zero is an important indicator to show the anti-reversal capability of dry gas seal. The results showed that the opening force and leakage rate of CO2real gas are greater than those of ideal gas, but the ratio of opening force to leakage rate less than those of ideal gas. When the dry gas seal performance of double-spiral groove lubricated by CO2gas is analyzed, it is necessary to consider the real gas effects of CO2gas. Double-spiral groove dry gas seals have some reverse rotation capability and the seals will normally operate when the reversal speed is less than that of the gas film zero stiffness. The gas film zero stiffness rotational speed reaches a maximum of 2 524 r/min as to the calculated example.

关闭

Copyright © 2020四川大学期刊社 版权所有.

地址:成都市一环路南一段24号

邮编:610065